Pages

Saturday, June 30, 2012

Aluminum Longshot Internals!

NerfSG Forum modder Zinv recently got a full set of aluminum Longshot internals custom fabricated and i had an opportunity to check out the setup...


The entire boltsled is made of one solid piece of precision machined aluminum.


Aluminum catch plate.


Full aluminum plunger head, plunger rod and plunger end-cap.


The aluminum parts are strong, yet lightweight... ideal replacement parts for modded Longshots.

For more information, contact Zinv at the NerfSG Forum.

11 comments:

  1. OMG i want a set!~ Looks stunning on the longshot :')

    ReplyDelete
  2. Should brass breech it too! Ultimate bling! :D

    ReplyDelete
  3. hey sg was wondering if a bbb stock spring + stock longshot spring is a fairly decent spring combo

    ReplyDelete
    Replies
    1. matamata,

      I've seen some modders use that spring combo before and it seems to work well too.

      Delete
  4. where do you get these aluminum parts from?

    ReplyDelete
    Replies
    1. Anonymous,

      As mentioned in the post, the aluminum parts were custom fabricated by Zinv at the NerfSG forum.

      Delete
  5. ok thanks for the info, pertaining to the spring would the priming draw be rather heavy?

    ReplyDelete
    Replies
    1. matamata,

      It all depends on the user's arm strength, just test and see if its suitable. :)

      Delete
  6. Hey I just realised, you put a ! at the end of all your headings :P

    ReplyDelete
    Replies
    1. Jack Kurt,

      Yup, it helps inject a bit more excitement into the headings. :)

      Delete
  7. How much would that cost to get?

    ReplyDelete